![]() ![]() If this happens, adjust your shutter speed to be faster, or use your ISO to compensate for the lack of light. ![]() The problem of camera shakeĬan you tell the difference between an out of focus shot, and one with camera shake? Your focus might be absolutely fine, but your shutter speed might be too slow for the lighting conditions, resulting in a shot where the image is smeared rather than blurred. Don't forget that the depth of field starts from the point you focus on, and extends in front of and behind that point - so if you have focussed on something other than your subject by mistake, then your depth of field will also be off. 1 to 3134 Random Auto Autumn Tram Wave Woman 1 Woman 2 Woman 3. Switch the Focus from M to AF on your Lens and Camera. By enabling autofocus on your camera lens, you’ll have full access to the autofocus camera modes discussed earlier. If you are using a wide aperture, the part of the image that is in sharp focus (the depth of field) will be small. Most focusing in-camera is controlled via a dedicated switch on the lens or body labeled AF/MF (Autofocus/Manual focus). For as long as you keep the shutter button half-pressed, the camera will hold the focus on the first place you focussed. Press the shutter button all the way to take the photo. ![]() Half-press the shutter button to achieve focus on the single focus point, and then - still with the shutter button half-pressed - move the camera to recompose your image how you want it. Once you can activate a single focus point you can use the focus-recompose method for quicker focussing. Look on the lens for a button that says "AF/MF" and switch it to MF, then you will be able to turn the barrel of the lens to change the focus. The most accurate way to get your focus correct is to switch from auto focus to manual focus. It usually gets it right, but if you wanted to focus on something in the background, something small in the frame, or on something that doesn't have much contrast (something all one colour for example), it might get it wrong. If your camera is on factory settings, it will take readings from the whole frame and decide where to fix the focus. And if you have face recognition software, it chooses to make faces in focus above all. It prioritises things closest to the camera. If you are using autofocus, your camera looks for contrast in your image to fix the focus on. If your images are a bit soft, a bit blurry or a bit out of focus, it's going to be one of only 3 reasons causing the problem - an autofocus issue, a depth of field issue, or a shutter speed issue. Try these troubleshooting steps before you take your camera to be looked at, if you think you have a sharpness problem. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |